IV Infusion Sets
Gravity infusion sets with and without a Y injection port, built around consistent tubing, chamber and connector components.
IV Infusion Sets: built as a system, not a part.
An infusion set has to perform reliably across every component — spike, drip chamber, tubing, roller clamp, injection port and connector. Kyoto's IV set platform is assembled inside its controlled environment with in-process checks placed along the production flow, and is offered with or without a Y injection port for additive medication.
Two configurations
Supplied with or without a Y injection port, so clinicians can choose the set that matches the infusion protocol.
Luer-slip connector with needle
Each set is supplied with a Luer-slip connector and a 21G × 1½" needle.
Cleanroom-controlled assembly
Assembly takes place within Kyoto's controlled medical-device manufacturing environment.
In-process and laboratory quality
Checks are placed within the production flow and supported by in-house laboratory review.
Configurations currently manufactured.
As supplied by the Kyoto product team. Dimensions in inches with millimetre equivalents.
| Product | Y port | Needle gauge | Needle length | Connection |
|---|---|---|---|---|
| IV Set without Y Port, Luer slip, with needle | No | 21G | 1½" (38 mm) | Luer slip |
| IV Set with Y Port, Luer slip, with needle | Yes | 21G | 1½" (38 mm) | Luer slip |
- Sterility state
- Stated in datasheet / IFU
- Sterilization method
- Stated in datasheet / IFU
- Primary packaging
- Stated in datasheet / IFU
- Shelf life
- Stated in datasheet / IFU
- Applicable standard(s)
- Stated in datasheet / IFU
- Registration by market
- Stated in datasheet / IFU
Product specifications are subject to the approved product design and may vary by market. Refer to the current datasheet and Instructions for Use.
Documentation for tender and qualification.
Datasheets and IFUs are issued per revision. Regulatory documents are provided on request by market.
- On request
Product datasheet
Current revision issued on request.
- On request
Instructions for Use
Approved IFU for the product and market.
- Gated
Regulatory / registration documents
Provided by product and destination market.
- On request
Packaging specification
Primary and secondary packaging and case configuration.
Frequently asked.
The Y injection port allows additional medication to be administered into the infusion line without disconnecting the set. The version without a Y port is used where no additive access is required.
Two: with Y port and without Y port. Both are supplied Luer slip with a 21G × 1½" needle.
Configuration (with / without Y port), expected annual volume, destination markets, packaging requirements and any tender documentation needs.
Auto-Disable Syringes
Designed for injection programs where preventing reuse is a critical safety requirement. Molded components, precision as…
Disposable Syringes
Single-use syringes with a secure Luer-lock needle connection, for general injection, aspiration and preparation workflo…
IV Cannulas
Pen-type peripheral IV cannulas in four gauges from 18G to 24G, built around controlled component geometry and repeatabl…
Evaluating infusion set supply?
Share the required configurations, annual volume, destination markets and packaging requirements. Our team routes your request to the appropriate contacts.